Gilles et al,

This may have an obvous answer but; How do I correlate the cross section drawings on plate 11 with their location on a profile plan?

There on many clues from the content of the cross sections but I haven't found a specific reference to their exact location on a profile or frame member.
-----------------
La réponse est peut être très simple, mais comment dois-je faire pour trouver la position des coupes montrées sur la planche 11 par rapport à la vue de profile.
Ces coupes contiennent beaucoup d'information mais je ne trouve pas de référence quant à leur exacte location.

Bob  

--Last edited by G. Korent on 2006-05-14 11:03:24 --

It's written in the text, but I don't have it yet with me before this evening. If someone has it ...

C'est indiqué dans le texte, mais je ne l'ai pas avec moi avant ce soir. Si quelqu'un l'a sous la main ...

Page 48 and 49 of the booklet.
Page 48 et 49 de la mono.

Gilles  

Thank Armand and Gilles you for your answer. Some lettered lines locating the cross sections on a profile drawing with arrows showing direction of view would certainly be helpful.

Yes, I have read page 48 and 49 in the monograph and what I understood from the text is the following. Hence my questions:

Section A: Frame 16 representing the forecastle breastwork

Question: I assume I am looking forward at the aft side of frame 16. Is that correct?

Section b (I assume this is equivalent the upper case B): Front of the midship frame

Question: I thought 28 through 33 were all referred to as midship or master frames (Perhaps erroneously). Which frame is actually considered the midship frame with reference Section B?

Section C: is located at the quarterdeck breast work.

Question: Am I looking aft at the forward side of frame 34?

Section D: Represents a section just behind the one previously mentioned (Section C)

Question:  Am I still looking aft from the aft side frame 34?

Section E: Located at the rear bulkhead.

Question:  Am I looking aft at the forward side of frame 53?

Thank you for your consideration.

Regards
Bob  

--Last edited by Rpowell on 2006-05-14 12:56:35 --

For all views, you are standing between the master frames, looking at the designed frame from the middle of the ship. There are 2 master frames: front master frame is called Mav (28), rear master frame is called Mar (33)

--------
Toutes les vues sont regardées depuis le centre du navire, placé entre les maitres couples. Il y a 2 maitres couples, Mav (28) à l'avant et Mar (33) à l'arrière.

--Message edité par Armand le 2006-05-14 15:04:41--

Hello Armand,

Thank you for your clarification on the direction of viewing.
I am embarrassed that I didn't see this sooner, but I just now noticed that each cross section on plate 11 has a small frame number in the keel cross section.  This locates the cross sections very precisely.
------------
Merci pour avoir clarifier la direction des couples.
Je suis quelque peu embarrassé de ne pas avoir vu ceci plus tôt, mais je viens juste de m'apercevoir que le numéro des couples est indiqué sur la quille dans les vues en coupe de la planche 11.  Ceci situe précisément les coupes.

Bob  

--Last edited by G. Korent on 2006-07-01 18:51:58 --